I have a 1978 Oasis water cooler. All that it needs is a new rubber ring in the water spigot. The spigot I have screws off and is a female threaded inside about an inch. Any ideas? or would your model screw on fine? I cannot tell if it is female from the photo
Hi. Sorry, I can't determine what kind of part you'd need for an older cooler, without a model #. For a small part like a rubber gasket, you can try the ones at your local hardware store and bring your spigot with you. This one appears to be female, with the hex nut at the right. Thanks!
By: Dave From:
Jun 26, 2012
We need 1/2" cambro spout kits. The diameter is not in the specs. We found other ones through another source, but they are 3/4 and too large. Both sizes fit 6 gallon cambros, so unnecessarily confusing on their part. What size is this one please?
Hi. If you had the model # of your Cambro container, it would be easier to see if this is listed as one of its parts. This replacement white faucet fits 6 gallon Beverage Dispenser model DSPR6, and the hole is 5/8". Thanks!
By: andy From: al.
Jun 28, 2012
what is diamiter of threads and length of threaded bulkhead
Hi. Sorry, that information is not available. This replacement white faucet is meant to just fit the Cambro 6 gallon Beverage Dispenser model DSPR6. Thanks!
By: CJ From: Cincinnati
Jul 19, 2013
Can you please tell me the outside diameter of the stem that goes through the container wall? I need to be sure that it will fit the hole in my dispenser. Also, what is the length from the centerline of the spout to the input end of the spigot.
Hi, this replacement faucet is meant to only fit the Cambro 6 Gallon Beverage Dispenser Model DSPR6. The hole the faucet fits into is 5/8 inches in diameter. Unfortunately, we do not have any additional information on the dimensions. Thank you.
By: Jan From: Kentucky
Nov 29, 2014
Can I get just the gaskets for a apigot?
The Cambro 46017 Replacement White Faucet for DSPR6 does not have a replacement gasket, it is part of the faucet. Thanks!